PM 10-V 1/2" Bowl Gouge - Bottom Feeder - Shaft Size .515

POWDERED METAL 10-V 1/2" Bowl Gouge - Bottom Feeder. They are shipped sharp.

Have a limited supply of bowl gouges in this PM steel. Remainder from a custom order and an opportunity to try our profile with the 10-V material.

There are two camps out there. Some prefer the M42 Steel and some the 10-V Steel. 

The Bottom Feeder grind is used on the inside of bowls especially for finish cuts, you can also use it on the outside of bowls from the foot to the top for all of your finishing cuts, if you learn to use this grind for finish cuts your sanding will be greatly reduced.  

You can always sand a piece into submission, but it is not much fun. ~ Jimmie

Related Videos Below